NYJC 2026 Prelim P2 QP
Uploaded by Grassy155 · 7 November 2026
NYJC 2026 prelim set
- P1 QP
- P1 MSanswers
- NYJC 2026 Prelim P2 QPyou're here
- P2 MSanswers
- P3 QP
- P3 MSanswers
Preview
Text from the first pages[Turn over NANYANG JUNIOR COLLEGE JC 2 PRELIMINARY EXAMINATION Higher 2 CANDIDATE NAME CLASS TUTOR’S NAME CENTRE NUMBER S INDEX NUMBER CHEMISTRY 9476/02 Paper 2 Structured Questions 14 September 2026 2 hours You must answer on the question paper You will need: Data Booklet INSTRUCTIONS • Answer all questions. • Use a black or dark blue pen. You may use an HB pencil for any diagrams or graphs. • Write your name, class, centre number and index number in the boxes at the top of the page. • Write your answer to each question in the space provided. • Do not use an erasable pen. Do not use correction fluid or tape. • Do not write on any bar codes. • You may use an approved calculator. INFORMATION • The total mark for this paper is 75. • The number of marks for each question or part question is shown in brackets [ ]. For Examiner’s Use 1 /5 2 /12 3 /10 4 /8 5 /8 6 /9 7 /23 Total /75 This document has 24 pages. Any blank pages are indicated. H
2 H2 Chemistry 9476/02 NYJC J2/26 PX [Turn Over For Examiner's Use Answer all questions in the spaces provided. 1(a) A sample of iron contains three different isotopes and has a relative atomic mass, Ar, of 55.8. (i) Define relative atomic mass. ......................................................................................................................... ......................................................................................................................... ..................................................................................................................... [1] (ii) Table 1.1 shows the abundances of two of the isotopes present in the sample of iron. Table 1.1 isotope relative isotopic mass relative % abundance 54Fe 53.9 6.0 56Fe 55.9 91.9 Use Table 1.1 to calculate the relative isotopic mass of the third isotope of iron in the sample. Show your working. [2] (b) Deduce the number of pairs of electrons in an iron(II) ion. ................................................................................................................................ [1]
3 H2 Chemistry 9476/02 NYJC J2/26 PX [Turn Over For Examiner's Use (c) The atomic radius of iron is 1.26 × 10–10 m. Suggest the change to the radius, if any, after an iron atom reacts to produce an Fe 3+ ion. Explain your answer. .................................................................................................................................... .................................................................................................................................... .................................................................................................................................... .................................................................................................................................... ................................................................................................................................ [1] [Total: 5]
4 H2 Chemistry 9476/02 NYJC J2/26 PX [Turn Over For Examiner's Use 2 Hydroxylammonium chloride, NH 3OHCl, is a toxic contaminant found in industrial wastewater. Environmental engineers must remove heavy metal contaminants like iron and hydroxylammonium ions, NH 3OH+, from the water , and manage halogenated by-products before environmental discharge. An engineer analyses a 1.00 dm3 wastewater sample containing an unknown concentration of NH3OH+ ions and 0.0150 mol dm-3 of iron(II) ions, Fe2+. (a) To remove the iron contaminants, the engineer slowly adds solid sodium hydroxide, NaOH to a 1.00 dm3 portion of the wastewater sample until the pH reaches 7.50. Determine whether a precipitate of Fe(OH)2 forms at this pH. [The solubility product, Ksp (Fe(OH)2) is 4.80 x 10-17] [2] (b) The treated wastewater from (a) is filtered to remove all other impurities, leaving only the NH3OH+ ions. To determine the concentration and chemical behaviour of the NH 3OH+ contaminant, the engineer performs a gravimetric analysis and a redox titration. In the gravimetric analysis, it was found that 10.0 cm3 wastewater sample contained exactly 1.04 g of hydroxylammonium chloride, NH3OHCl (Mr = 69.5). In the redox titration, a 25.0 cm 3 sample of the wastewater is acidified and titrated against 2.00 mol dm-3 acidified potassium dichromate. During this reaction, NH3OH+ is oxidised to a gaseous nitrogen oxide product. 12.50 cm3 of the acidified potassium dichromate solution is required for complete reaction with all the NH3OH+ ions present. (i) Using data from the gravimetric analysis, c alculate the initial concentration of NH 3OH+ ions in the wastewater sample in mol dm–3. [1]
5 H2 Chemistry 9476/02 NYJC J2/26 PX [Turn Over For Examiner's Use (ii) The possible gaseous nitrogen oxides are NO, NO2, N2O3. Using your answer in (i), calculate the number of moles of electrons transferred per mole of NH3OH+. Deduce the final oxidation state of nitrogen in the gaseous nitrogen oxide product and suggest the identity of the nitrogen oxide. [3] (c) The volatile halogens generated during industrial water treatment must be recaptured. (i) Describe and explain the trend in volatility down Group 17 from chlorine to iodine in terms of their structures and bonding. ......................................................................................................................... ......................................................................................................................... ......................................................................................................................... ......................................................................................................................... ..................................................................................................................... [2] (ii) During high temperature decomposition treatments, small concentrations of hydrogen halides, HX may form as gaseous byproducts. Explain the trend in the thermal stability of the hydrogen halides. ......................................................................................................................... ......................................................................................................................... ......................................................................................................................... ..................................................................................................................... [2]
6 H2 Chemistry 9476/02 NYJC J2/26 PX [Turn Over For Examiner's Use (d) After the wastewater has been treated, an engineer tests for residual chloride ions by adding aqueous silver nitrate. 1 cm3 of water is added to 1 cm3 of 1 mol dm –3 silver nitrate solution. If no precipitate is formed, the water is considered to be safe for reuse in the manufacturing plant. What is the maximum allowed concentration of chloride ions that can be present in the water? Ksp of AgCl = 1.8 x 10−10 mol2 dm−6 [2] [Total: 12]
7 H2 Chemistry 9476/02 NYJC J2/26 PX
Content continues in the PDF. Download PDF
