YIJC 2026 Prelim P2 QP
Uploaded by Grassy155 · 8 November 2026
YIJC 2026 prelim set
- P1 QP
- P1 MSanswers
- YIJC 2026 Prelim P2 QPyou're here
- P2 MSanswers
- P3 QP
- P3 MSanswers
- P4 QP
Preview
Text from the first pages©YIJC 9478/02/JC2/PRELIM/2026 [Turn over YISHUN INNOVA JUNIOR COLLEGE JC 2 PRELIMINARY EXAMINATION Higher 2 CANDIDATE NAME CG INDEX NO PHYSICS Paper 2 Structured Questions You must answer on the question paper. No Additional Materials are required. 9478/02 25 August 2026 2 hours INSTRUCTIONS INFORMATION This document has 24 pages. Any blank pages are indicated. For Examiner’s Use Paper 1 /30 Paper 2 1 /12 2 /7 3 /10 4 /6 5 /9 6 /10 7 /21 Penalty Total /75 • Answer all questions. • Use a black or dark blue pen. You may use an HB pencil for any diagrams or graphs. • Write your name, CG and index number in the boxes at the top of the page. • Write your answer to each question in the space provided. • Do not use an erasable pen. Do not use correction fluid or tape. • You may use an approved calculator. • The total mark for this paper is 75. • The number of marks for each question or part question is shown in brackets [ ].
©YIJC 9478/02/JC2/Prelim/2026 2
©YIJC 9478/02/JC2/Prelim/2026 [Turn over 3
©YIJC 9478/02/JC2/Prelim/2026 4 Answer all the questions in the spaces provided. 1 (a) One end of a cable is connected to a fixed point. A load is attached to the other end so that the wire hangs vertically. The initial unstretched length L, the diameter d of the cable, the applied load F and the resulting extension x are measured as L = 2.000 ± 0.002 m d = 0.40 ± 0.02 mm F = 25.0 ± 0.5 N x = 1.20 ± 0.06 mm The Young modulus E of the material of the cable is calculated by using the expression 2 4FLE dxπ= Calculate E and the uncertainty in its value. Show how your answers were obtained. E = …………………….. ± …………………….. N m–2 [4]
©YIJC 9478/02/JC2/Prelim/2026 [Turn over 5 (b) A uniform rectangular sign of length 0.80 m and width 0.68 m is fixed at its corner points A and B to a wall. The sign is also supported by a wire CD, as shown in Fig. 1.1 Fig. 1.1 The sign has weight W and centre of gravity at point E. The sign is held in a vertical plane with side BC horizontal. The wire is at an angle of 35° to side BC. The tension in the wire is 54 N. The force exerted on the sign at B is only in the vertical direction. (i) State two conditions necessary for the sign to be in equilibrium. …………………………………………………………………………………………………….. …………………………………………………………………………………………………….. …………………………………………………………………………………………………….. ……………………………………………………………………………………………..….. [2] (ii) Explain why the force on the sign at B does not have any moment about point A. …………………………………………………………………………………………………….. …………………………………………………………………………………………………. [1] (iii) Determine the weight W of the sign. W = …………………….. N [2]
©YIJC 9478/02/JC2/Prelim/2026 6 (iv) Calculate the total vertical force exerted by the wall on the sign at points A and B. total vertical force = …………………….. N [2] (v) The attachment at corner point B is removed but the sign remains stationary, supported solely by the wire CD and its remaining contact with the wall at corner point A. On Fig. 1.1, draw an arrow to show the direction of the force exerted by the wall on the sign at point A. [1] [Total: 12]
©YIJC 9478/02/JC2/Prelim/2026 [Turn over 7 2 Two positively charged particles X and Y of masses 3m and 2m respectively, move directly towards each other with the same speed as illustrated in Fig. 2.1. Fig. 2.2 shows how the velocity of each particle varies with time during the collision. The collision is elastic. (a) Describe the energy change of the system that takes place during the collision. …………………………………………………………………………………………………............... …………………………………………………………………………………………………………… …………………………………………………………………………………………………………… ……………………………………………………………………………………..…………………...[1] (b) Explain, using features of the graph, how it may be deduced that X has the larger mass. …………………………………………………………………………………………………............... …………………………………………………………………………………………………............... …………………………………………………………………………………………………............... ………………………………………………………………………………………..………………..[2] v v X Y + + 3m 2m Fig. 2.1 Fig. 2.2 X Y
©YIJC 9478/02/JC2/Prelim/2026 8 (c) Determine, in terms of v, the speeds of X and Y after the collision. Show your workings. speed of X = ………………….. speed of Y = ………………….. [4] [Total: 7]
©YIJC 9478/02/JC2/Prelim/2026 [Turn over 9 3 (a) Explain what is meant by simple harmonic motion. ……………………………………………………………………………………………………….…… ……………………………………………………………………………………………………….…… ……………………………………………………………………………………………………….…… ……………………………………………………………………………………………….……….. [2] (b) Fig. 3.1 shows the variation with time t of the height h above the ground of an object of mass 37 kg that is undergoing vertical simple harmonic motion. Fig. 3.1 For the oscillations of the object, (i) determine the amplitude x0, x0 = …………………….. cm [1] (ii) show that the angular frequency is 1.6 rad s−1, [1] (iii) determine the total energy E. E = …………………….. J [2]
©YIJC 9478/02/JC2/Prelim/2026 10 (c) On Fig. 3.2, sketch the variation with time t of the kinetic energy EK of the object. Fig. 3.2 [2] (d) On Fig. 3.3, sketch the variation with the height h above the ground of the kinetic energy EK of the object. Fig. 3.3 [2] [Total: 10] t / s 2 4 6 8
Content continues in the PDF. Download PDF
