2025 NYJC H3 Chem 9813 P1 Prelim Insert
Uploaded by Kozak327 · 10 November 2026
Preview
Text from the first pagesH3 Chemistry 9813/01 NYJC J2/2025 PX [Turn Over NANYANG JUNIOR COLLEGE JC 2 PRELIMINARY EXAMINATION Higher 3 CHEMISTRY 9813/01 Paper 1 22 September 2025 INSERT Candidates answer Secti2 hours 30 minutes READ THESE INSTRUCTIONS FIRST This insert contains information for Question 1. Do not write your answers on the insert. 2 3 4 5 This document consists of 4 printed pages H
2 H3 Chemistry 9813/01 NYJC J2/2025 PX Information for Question 1 Perfluorooctanoic acid (PFOA), a synthetic compound belonging to the per - and polyfluoroalkyl substances (PFAS) family, is notorious for its environmental persistence, bioaccumulation potential, and adverse health effects, posing a major challenge to environmental safety. Effective removal and detection of PFOA remains a challenge for conventional capture materials due to its unique molecular structure. perfluorooctanoic acid (PFOA) Abstract 1 describes a method for the removal and detection of PFOA using the dual-functional metal-organic framework (MOF). Abstract 2 describes a method for the removal and detection of PFOA using the cationic covalent organic framework (COF). Abstract 1 (Journal of Materials Chemistry C, 2025) MOFs are a class of porous crystalline materials built from metal nodes and organic linkers . A dual-functional MOF, UiO-66-N(CH3)3+, is designed for selective removal and detection of PFOA in water. This MOF is synthesised through the post-synthetic modification of UiO-66-NH2(Zr) with methyl iodide. Beyond its high sorption capability, it is also a highly efficient fluorescence "turn -on" sensor for PFOA detection via a straightforward indicator displacement assay (IDA) by loading the MOF with the anionic dye sulforhodamine B (SRB ). When bound within the MOF, SRB is nonfluorescent; however, upon exposure to PFOA, it is displaced and regains its strong fluorescence in solution. SRB is known for its pH-independent fluorescence over a wide range (typically pH 3-10). Metal-organic framework (MOF), UiO-66-NH2(Zr) SRB
3 H3 Chemistry 9813/01 NYJC J2/2025 PX [Turn Over Compared to conventional detection methods, fluorescence -based sensors emerg e as a promising solution for realtime, on-site monitoring of water bodies. Fig. 1.1 shows the schematic illustration of the synthesis of UiO-66-N(CH3)3+, adsorption of PFOA via ion exchange, and IDA-based fluorescent sensor for PFOA. Fig. 1.1 Summary of findings PFOA adsorption capacity and selectivity The time-dependent adsorption behavior at low PFOA concentrations followed a pseudo-first-order kinetic model, in contrast to the pseudo-second-order kinetics observed at higher concentrations. At low PFOA concentrations, the number of available MOF adsorption sites greatly exceeds the number of PFOA molecules, allowing the concentration of adsorption sites to be treated as effectively constant. UiO-66-N(CH3)3+ also maintained a high PFOA adsorption capacity despite the presence of some salts (e.g. KCl, CaCl2 and Na2SO4) at high concentrations. The material retained over 93% of its original PFOA adsorption capacity after five consecutive cycles. Mechanism of PFOA adsorption FT–IR spectra of UiO -66-N(CH3)3+ after PFOA adsorption from a 100 ppm solution revealed the emergence of new peaks at approximately 1240, 1204, and 1149 cm –1, corresponding to the vibrational modes of –CF2. Additionally, the symmetric C–O stretching band (1415–1380 cm–1) associated with the ligand coordination at the Zr metal center did not exhibit any noticeable shift. IDA-based Fluorescence turn-on detection of PFOA Efficient dye loading was facilitated by electrostatic interactions between the positively charged quaternary ammonium groups of the MOF and the negatively charged sulfonate groups of SRB. Interestingly, structurally similar non-fluorinated alkyl carboxylic acids such as lauric and octanoic acid did not induce a “turn-on” fluorescence response in the UiO -66-N(CH3)3+@SRB system. Similarly, smaller carboxylic acids (e.g., acetic and trifluoroacetic acid) and other small organic molecules (e.g., phenol and nitrobenzene) failed to generate any detectable fluorescence enhancement under the same conditions. Abstract 2 (Nature Communications, 2024, 15, 10490) CH3I PFOA UiO-66-NH2 UiO-66-N(CH3)3+ UiO-66-N(CH3)3+ UiO-66-N(CH3)3+@SRB free SRB fluorescent UiO-66-N(CH3)3+@PFOA SRB
4 H3 Chemistry 9813/01 NYJC J2/2025 PX This study explores a cationic COF, TG-PD COF. It shows remarkable selectivity and sensitivity to PFOA. The data from the adsorption kinetics were fitted against the pseudo-second order adsorption model in a linearised form represented equation 1. equation 1 t Qt = 1 kQe2 + t Qe Where t is the time in min, Qt is the PFOA uptake capacity by the COF adsorbent at any time in mg g–1, Qe is the PFOA uptake capacity by the COF adsorbent at equilibrium in mg g–1, and k is the rate constant of adsorption in g mg–1 min–1. Fig. 1.2 shows the adsorption kinetics data fitting for high PFOA and COF concentrations using the pseudo-second order model. The y-intercept is at 2.06 10–4 min g mg–1. Fig. 1.2 Copyright Acknowledgements Question 1 Abstract 1 © R. DALAPATI, J. Shi, M. Hunter and L. Zang, J. Mater. Chem. C, 15 July 2025. Abstract 2 © Jrad, A., Das, G., Alkhatib, N. et al. Nat Commun 15, 10490, 2 December 2024. t Qt / min g mg–1 0 500 1000 1500 2000 2500 0 200 400 600 700 800 1000 1200 1310 t / min
Content continues in the PDF. Download PDF
