2025 DHS-HCI H3 Chemistry Prelim key (suggested)
Uploaded by Kozak327 · 10 November 2026
Preview
Text from the first pages1 Hwa Chong Institution C2 Preliminary Examination Question Answer Marks 1(a)(i) Nanorods have high aspect ratio, providing large surface area for application such as catalyst and gas sensors. [1] 1 1(a)(ii) ZnO + 2H+ d Zn2+ + H2O / ZnO + H2CO3 → ZnCO3 + H2O ZnO reacts with acid to form Zn(II) salts, which cause the ZnO nanorod device to degrade. 1 1(a)(iii) Aspect ratio = 4x10-6 / 200x10-9 = 20 1 1(b)(i) Ksp = 3.0 x 10−17 Let solubility of Zn(OH)2 = x 4x3 = 3.0 x 10−17 x = 1.96 x 10− mol dm− 1 1(b)(ii) IP > Ksp, Zn2+ and OH− in the solution will precipitate out spontaneously as Zn(OH) 2 in large amounts before ZnO nanorods can be formed, leading to depletion of reactants for further ZnO nanorods growth. 1 1(c)(i) (CH₂)₆N₄ + 6 H₂O → 4 NH₃ + 6 HCHO 2 1(c)(ii) As hydrolysis of HMTA proceeds, a steady supply of ammonia, and therefore OH − is maintained, instead of a sudden spike in concentration. Ammonia is a weak base, small extent of dissiociation to form OH-. This helps to maintain the low supersaturaltion level of OH− in the reaction mixture. 1 Formation of soluble complex between Zn2+ and NH3 effectively removes free Zn2+ in the reaction mixture, maintaining a low concentration, preventing an immediate bulk precipiration of Zn(OH)2. 1 1(c)(iii) Excess amount is needed so that a soluble complex [Zn(OH) 4]− can be formed for ZnO nanorods growth in equation 2. OR The Zn(OH)2 formed would deplete the reactant ions and no crystal growth can occur. 1 1(d)(i) Sum of enthalpy change of formation of products = -350 + 4(-81) = −674 kJ mol–1 Sum of enthalpy change of formation of reactants = -473 + (-286) = −759 kJ mol–1 Hr = −674 − (−759) = + 85 kJ mol–1 2 1(d)(ii) For reaction to be spontaneous, G < 0 H < TS 85 x 1000 < 247 x T T > 344.1 K 1 Assumption: H and S remains constant with temperature. 1 1(d)(iii) A higher temperature might be used to increase the rate of reacton 1 Not too high to cause the boiling of reaction mixture, which might affect the crystal growth. 1 1(e)(i) Nucleophilic attack of methanal by hydroxide ion to form hydrated methanal. 1 Nucleophilic attack of another methanal by alkoxide ion, followed by protonation 1 1(e)(ii) The last step where the substrate is heated to high temperature in the oven could remove all the organic polymer. Polymer has relatively low boiling point due to weak dispersion force between the polymer chains. 1 1(f) The solvent used is water, which is environmentally friendly / cleaner. The temperature used in the synthesis process is relatively low, reducing the energy input needed. The method is simple, only involves mixing of a few simple chemicals and simple setup. This also means that it is easily scalable. Any 2 resonable points 2
2 Hwa Chong Institution C2 Preliminary Examination Question Answer Marks 2(a)(i) SN2 and the electrophilic C in CH3Br is easily attacked by nucleophile as it is not sterically hindered or the methyl cation formed via SN1 mechanism is unstable 1 the relative rates of reaction changes significantly with different nucleophiles, suggesting that the rate of reaction depends on the nucleophile unlike S N1 mechanism 1 2(a)(ii) In PhO−, the lone pair of electrons on O is delocalised into the benzene ring and is less available for donation compared to OH− or The bulky phenyl ring in PhO− makes it more difficult for PhO− to approach the electrophilic carbon in CH3Br than OH− due to steric hindrance. 1 The S in PhS− has a larger, more polarisable electron cloud than the O in OH− and thus PhS− is a stronger nucleophile than OH−. 1 2(a)(iii) Propanone is a polar aprotic solvent which solvates the PhO− anion less well compared to ethanol, a polar protic solvent. This makes the PhO− anion more available for nucleophilic attack and hence the rate of SN2 reaction increases. 1 2(b) SN1 mechanism occurs for the reaction of U with OH− For U, the benzyl cation intermediate formed is resonance -stabilised due to the delocalisation of the lone pair of O into the benzene ring. O Cl O + + Cl− 1 SN2 mechanism occurs for the reaction of V with OH− For V, the nitro group on the benzene ring reduces the extent to which the positive charge on the benzyl cation is delocalised, making the carbocation less stable and less likely to form via a SN1 mechanism or the electron-withdrawing nitro group on the benzene ring will disperse the negative charge on the transition state in a SN2 reaction, stabilising it. 1 2(c)(i) Y is the more substituted and hence more stable alkene based on Zaitsev rule (i.e. Y is the thermodynamic product) or Among the two electrophilic carbon atoms (see resonance structures below), the primary C is less sterically hindered than the secondary C. The attack of the CH3OH nucleophile on the less sterically hindered primary C leads to a more stable TS. Hence Y is formed faster with a lower Ea (i.e. Y is also the kinetic product). + + 1 2(c)(ii) Z and values suggest three sets of alkene protons 1
3 Hwa Chong Institution C2 Preliminary Examination Question Answer Marks H H H H H H a a b bc c = 5.0 or 5.1 ppm = 6.3 ppm = 5.0 or 5.1 ppm 1 2(c)(iii) Cl + HW −Cl− Z + CH3OH CH3 O + H H Cl− Z + CH3OH + HCl Loss of leaving group to form carbocation intermediate 1 Deprotonation and formation of Z 1 2(d)(i) Carbon 1: CH3 < CH2C < CHC2 < Br Configuration is S 1
4 Hwa Chong Institution C2 Preliminary Examination Question Answer Marks 2(d)(ii) Br H H HHHHHHHHHHHHHHHHHHHHHH H HHHHHHHHHHHHHHHHHHHHHH S1 − OCH3 (a) (a) (b) CH3O − P Q (b) Br H H H HHHHHHHHHHHHHHHHHHHHHH H CH3 Br H HHHHHHHHHHHHHHHHHHHHHH CH3O − (more stable conformer) (less stable conformer) S2 P Correct configuration of substituents on cyclohexane ring for S1 and S2 1 Curly arrows showing E2 elimination via antiperiplanar arrangement of C –H and C–Br bonds 1 For S1, there are two -hydrogen atoms in the ring in axial position, so it forms two alkenes, P and Q. For S2, there is only one -hydrogen atom in the ring in axial position, so it forms only one alkene, P. 1 2(d)(iii) Rate of E2 reaction will be slower for S2 1 S2 has to do a ring flip to form the less stable conformer where the bulky –CH(CH3)2 group is in the axial position, causing steric repulsion. or in the equilibrium between the conformers of S2, that with the bulky –CH(CH3)2 group in the axial position is at a much lower concentration. 1 2(d)(iv) Base = (C2H5)3CO− (allow any sterically hindered strong base) 1 It will be easier for the sterically hindered base to approach the less hindered H atom of the methyl substituent outside the ring (also in antiperiplanar arrangement with C–Br bond) than the H atoms on the ring itself. 1
5 Hwa Chong Institution C2 Preliminary Examination Question Answer Marks 3(a)(i) O is more electronegative than C, therefore its electrons experience more nuclear attraction which decreases the energies of all its orbitals. [1] 1 3(a)(ii) The AOs of MO 1 overlap out of phase with each other while the AOs of MO 2 overlap in phase with each other. [1] 1 The lobes around C are larger than the lobes around O. This shows that MO 1 is closer in energy to the higher energy 2p orbitals of the less electronegative C. ie. MO 1 is higher in energy than MO 2. 1 3(a)(iii) 3dxz or 3dyz (REJECT: 3dz2) 1 3(a)(iv) It is a strong ligand because electron density is donated from the metal to the ligand, strengthening the metal-ligand bond. 1 The C≡O bond is weakened because electron density from the metal enters the anti -bonding MO 1. This will decrease the bond order of C≡O. 1 3(b)(i) stereoisomers OR diastereomers OR fac-mer isomers 1 Both of them are not optically active because they both possess an internal plane of symmetry which makes their mirror images non-superimposable. 1 3(b)(ii) More than 1750 but less 21
Content continues in the PDF. Download PDF
