2026 RI H3Chem Prelims Answers
Uploaded by Kozak327 · 10 November 2026
Preview
Text from the first pages2026 RI H3 Chemistry Preliminary Exams (Suggested Solutions) 1 1(a)(i) Unlike H-type cells, in GDL-based reactors, CO2 is supplied directly to the catalyst surface . This increases CO2 concentration at the cathode/electrode, leading to higher rate of electron transfer involved in CO2 reduction per unit area of cathode/electrode. 1(a)(ii) When flooding occurs, H2O at the cathode also undergoes reduction , resulting in additional electrons required. Hence to maintain the same current density for CO 2 reduction, total current density needs to increase, which can be achieved by applying a higher cell potential. OR From equation 1 in (b): 2CO2(g) + 12H+(aq) + 12e– ⇌ C2H4(g) + 4H2O(l) E = +0.09 V When flooding occurs, [CO2] at the cathode decreases or [H2O] at the cathode increases. This causes the equilibrium position to shift towards the left, causing E(CO2/C2H4) to become less positive. As a result, the Ecell for the CO2 reaction becomes more negative, and requires a higher cell potential to drive the reaction. 1(a)(iii) In Mode I, the polymer does not uniformly cover the catalyst surface . Some sites remain exposed to H 2O and are not effectively supplied with CO 2. In Mode II, the uniform layer prevents/minimises the exposure of catalyst surface to H2O. 1(a)(iv) Nafion contains polar sulfonic acid groups which form hydrogen bonds with H2O. This leads to more H2O/increases [H2O] at the catalyst surface as compared to other polymers, resulting in greater H2O reduction and lowering the selectivity for C2+ products. 1(b)(i) EC2H4 = 0.09 – 1.23 = –1.14 V ΔGo = –(12)(96500)(–1.14) = +1.32 x 103 kJ mol–1 >0 (not thermodynamically feasible) 1(b)(ii) cell potential required to be applied = 1.14 x 0.870.51 = +1.94 V 1(b)(iii) rate = (2.0 x 0.87 x 1.0)12 x 96500 = 1.50 x 10–6 mol s–1 1(b)(iv) rate = 1.50 x 10–6 x 60 x 24000 = 2.16 cm3 min–1 concentration of C2H4 = ( 2.16 25 ) x 106 = 8.64 x 104 ppm If use given rate in question: rate = 1.00 x 10–6 x 60 x 24000 = 1.44 cm3 min–1 concentration of C2H4 = ( 1.44 25 ) x 106 = 5.76 x 104 ppm 1(b)(v) Increasing the gas flow rate does not affect the rate of formation of C 2H4 as the rate of formation of C 2H4 only depends on the current supplied and/or applied cell potential which remains constant. 1(b)(vi) Changing the catalyst from Cu to Ag will decrease the yield of C2+ products. Since Ag adsorbs CO more weakly than Cu, CO is less likely to remain bound on the catalyst surface long enough for further reduction to occur. Instead, CO is more likely to desorb as CO gas.
2026 RI H3 Chemistry Preliminary Exams (Suggested Solutions) 2 1(b)(vii) C2+ products contain C–H and C–C bonds that can release more energy upon combustion than CO. OR C2+ are generally liquid fuel which can be stored more efficiently compared to CO which are gaseous fuel. 1(c)(i) Halving the partial pressure of CO 2 significantly reduces [CO2] at the catalyst surface. This reduces the formation of CO at the surface, which in turn decreases the formation of C 2+. Less current density will be involved in the formation of C 2+ products as compared to other products. Hence according to equation 1.1, FC2+ decreases. 1(c)(ii) ΔE = – (0.059212 ) x lg4 = –0.00297 V 1(d) High current densities ensure that CO 2 reduction is carried out at a sufficiently fast rate , allowing effective use of available electrical energy. High Faradaic efficiency ensures that most of the electrons supplied are used to form the desired products rather than side reactions , allowing for efficient conversion of renewable energy into useful fuel. 2(a)(i) Condensation 2(a)(ii) All C=N bond in F are E isomers. C : C atom has higher atomic number and hence higher priority over H atom N : C atom has higher atomic number and hence higher priority over lone pair of e− Since the two hig her priority groups are on opposite side of the C=N bond, the stereochemistry is E. 2(a)(iii) 10 2(a)(iv) In F, there are intramolecular hydrogen bonds formed between the phenol H and the neighbouring N and O atoms which are close in proximity. This results in greater stability of F and therefore the reaction favours the formation of F. 2(a)(v) Molecule absorbs energy of specific wavelength within the UV -visible spectrum. Energy is used to excite an electron from a lower energy level to a higher energy level. The energy absorbed corresponds to the energy gap between the energy levels. 2(a)(vi) F has a much greater extent of conjugation compared to E. As a result, the HOMO-LUMO gap in F is much smaller and it would absorb at a much longer wavelength. 2(a)(vii) Oxidation state of Co = +2
2026 RI H3 Chemistry Preliminary Exams (Suggested Solutions) 3 2(b)(i) I II III IV enantiomers pairs: I & II, III & IV diastereomers/ fac-mer isomers: I & III, I & IV, II & III, II & IV 2(b)(ii) The average Ru–N bond length increases with increasing number of alkyl substituents on the pyridine ring. This is because the alkyl substituents hinder the approach of the ligands towards the metal center when forming the complex. 2(b)(iii) As the distance between Ru(II) and N increases (or Ru–N bond length increases), the ligands repel electrons in the d orbitals of Ru(II) to a lower extent, resulting in a smaller splitting of the d orbitals. As a result, longer wavelengths of light (red-shift) are absorbed to promote the electrons from the lower energy d orbital to the higher energy d orbital . Hence the complementary colour observed is different (red-shift). 2(c)(i)
2026 RI H3 Chemistry Preliminary Exams (Suggested Solutions) 4 2(c)(ii) 2(c)(iii) As the HOMO of 1,3-butadiene donates electron density to Cr, electron density/ bond order between C1−C2 and C3−C4 decreases more significantly. Hence, the C1−C2 and C3−C4 bond lengths in the coordinated 1,3-butadiene are larger than those in free 1,3-butadiene. As the LUMO of 1,3-butadiene accepts electron density from Cr, electron density/ bond order between C2−C3 increases more significantly. Hence, the C2−C3 bond length in the coordinated 1,3-butadiene is smaller than that in free 1,3-butadiene. 3(a)(i) Indole is aromatic as all atoms are coplanar and the compound has an uninterrupted cyclic π system due to the continuous overlap of p orbitals on all the atoms. It has (4n + 2) π electrons (10 π electrons), as the N atom contributes 2 electrons to the system of delocalised π electrons. 3(a)(ii) Indole is less basic than quinoline. In indole, the lone pair of electrons on N is located in an unhybridised p orbital which overlaps with the p orbitals of the other atoms in the ring. Therefore, the lone pair is delocalised and less available for coordination with a proton. In quinoline, the lone pair of electrons on N is located in an sp2 hybrid orbital. Hence, the lone pair is not delocalised into the ring and more available for coordination with a proton. 3(a)(iii) 3(b)(i) C-5 undergoes electrophilic substitution preferentially as a more stable intermediate is formed due to the electron-donating ethyl group bonded to the positively charged carbon in one of the resonance structures.
2026 RI H3 Chemistry Preliminary Exams (Suggested Solutions) 5 3(b)(ii) Mass Spectrum No. of carbon atoms = n= 100 1.1 ( 10 100) = 9.09 ≈ 9 Mr of P = 150 From NMR spectrum, there are 14 H atoms. Mass of remaining atoms = 150 − (9×12) −14 = 28, hence there are 2 nitrogen atoms. Molecular formula of P is C9H14N2. m/e Species 135 Loss of CH3 121 Loss of C2H5 or
Content continues in the PDF. Download PDF
