2026 NYJC H3 Chem 9813 P1 Answers
Uploaded by Kozak327 · 10 November 2026
NYJC 2026 set
- P1 QP
- 2026 NYJC H3 Chem 9813 P1 Answersyou're here
Preview
Text from the first pagesH3 Chemistry 9813/01 NYJC J2/2026 PX [Turn Over Nanyang Junior College 2026 JC2 Preliminary Examination H3 Chemistry Suggested Solutions Section A 1 (a) They do not contain chlorine atoms. Hence, they are unable to undergo homolytic fission to form chlorine radicals in the stratosphere that depletes the ozone layer. (b) (i) For R600a, qv = (3100 363)/1000 = 1130 kJ m−3 For R32, qv = (16380 315)/1000 = 5160 kJ m−3 (ii) • Although the qv of R32 is 4.6 times higher than R600a, • its GWP100 is 169 times larger than R600a. • Hence, R600a is a better refrigerant as it has a significantly lower impact on global warming. (iii) NH3 is toxic to the occupants which may cause damage to the lungs when inhaled at high levels if it leaks inside the residential areas. (c) (i) Advantage: HFOs will not linger in the atmosphere for long. Hence, they will be less likely to reach the stratosphere and deplete the ozone layer. Disadvantage: HFOs may undergo addition polymerisation due to the C=C bonds under high pressure and temperature. Hence, this may decrease their effectiveness in the cooling effect. (ii) Step 1: D (to B) Step 2: B (to A) Step 3: A (to C) Step 4: C (to D) (d) (i) Hsol(NH4SCN(s)) = Hhyd(NH4+(g)) + Hhyd(SCN−(g)) − LE(NH4SCN(s)) = (−307) + (−280) − (−611) = +24 kJ mol−1 (ii) • n(NH4SCN) = 15.3/76.1 = 0.2010 mol • q = 0.2010 24 = 4.825 kJ • q = mcT 4825 = (84.7)(4.18)T T = 13.62 K • Lowest temperature reached = 293 − 13.62 = 279.4 K or 6.4 C (iii) • Since the solution temperature falls below room temperature, heat will continuously leak into the styrofoam cup from the warmer surroundings, warming the solution. • The heat capacity of the solution, c, may be higher than water (i.e. > 4.18 J−1 g−1 K−1), causing the T to be lower than expected. ( T = q mc) Hence, the lowest temperature reached may be higher than expected. • The density of the solution, , may be higher than water (i.e. > 1.00 g cm −3), causing the T to be lower than expected. (T = q ρVc) Hence, the lowest temperature reached may be higher than expected. • The heat capacity of the styrofoam cup was assumed to be zero but is non-negligible in practice so the cup releases heat into the solution as it cools down. • The salt may not dissolve instantly or completely, leading to a slower temperature drop during which continuous ambient heat gain occurs.
2 (e) 2240 cm−1: CÐN bond in the aqueous/liquid state 2215 cm−1: CÐN bond in the solid state In the dense solid crystal lattice, strong electrostatic interactions or hydrogen bonding between the NH4+ ions and the lone pairs on the nitrogen atom of the SCN − ions polarised and weaken / lengthen the C ÐN bond (lowering its force constant), resulting in a shift to a lower stretching frequency. 2 (a) (i) Na metal used in step 1 is to deprotonate the alcohol group in A to generate a stronger nucleophile to react with B. Concentrated HC l used in step 2 is to protonate the tertiary amine to make it a better leaving group for E2 to occur. (ii) Z. The higher priority substituents, CH2F and F, with higher atomic numbers on each carbon of the C=C bond are both on the same side. (iii) CH3F CH2F H R CH3 RH3C H CH2F CH3 F or (iv) N N N N N N most stable Step 3 proceeds via an SN1 mechanism as the intermediate carbocation formed is stable due to the positive charge being dispersed over to the N atom (where every atom has a complete octet structure) as the p orbital of N atom overlaps with the p orbitals of the +C-C-N bond. Step 3 does not proceed via an S N2 mechanism as the nucleophile D is unable to attack the electron deficient C atom due to the steric hindrance caused by the bulky aromatic ring. (v) NH2 N N Cl (b) (i) In an external applied magnetic field, all protons have their magnetic moments either parallel with the field or antiparallel to it. As a result, the degenerate spin states split into two states of unequal energy. The energy difference between the two levels is small and falls within the radio frequency region. The nuclear magnetic resonance phenomenon occurs when nuclei parallel with an applied magnetic field are induced to absorb energy and change their spin orientation such that it is antiparallel to the applied magnetic field.
3 (ii) Number of C atoms, n = 1001.1 × 6.6100 = 6 Based on the relative peak areas from the 1H NMR spectra, there are 13 protons in the R group of ROH (since the signal due to O−H proton is not shown). Hence, the molecular formula of ROH is C6H13OH. chemical shift, / ppm relative peak area Splitting pattern Deduction 4.36 2 doublet It is a 1:1 doublet and suggests that there is 1 proton on the adjacent carbon. Hence, there are 2 protons that belong to CH 2 group that is bonded to 1 CH group. 1.63 1 multiplet It is a multiplet and suggests that there is a total of 6 protons on the adjacent carbons. Hence, there is 1 proton that belongs to CH group that is bonded to 3 CH2 groups. 1.31 4 quintet / multiplet It is a multiplet and suggests that there is a total of 4 protons on the adjacent carbons. Hence, there are 4 protons that belong to 2 CH 2 groups that are each bonded to 1 CH group and 1 CH3 group. 0.85 6 triplet It is a 1:2:1 triplet and suggests that there are 2 protons on the adjacent carbon. Hence, there are 6 protons that belong to 2 CH 3 groups that are each bonded to 1 CH2 group. Hence, the structure of ROH is CH2OH C HCH2 CH3 CH2 CH3 . (iii) Use IR spectroscopy. A peak between 700 – 800 cm−1 due to C−Cl bond stretching will be present for G but will be absent for remdesivir. Or A peak between 2200 – 2250 cm −1 due to C ÐN bond stretching will be present for remdesivir but will be absent for G. Or A peak between 3200 – 3600 cm −1 due to O −H bond stretching will be present for remdesivir but will be absent for G. Or A peak between 1710 – 1750 cm−1 due to C=O bond stretching of the ester will be present for remdesivir but will be absent for G.
4 3 (a) (i) • increasing nucleophilicity: alkoxide < azanide < thiolate Oxygen is highly electronegative and holds its lone pair of electrons relatively tightly, making it less readily available for donation. Nitrogen is less electronegative than oxygen, so the lone pair of electrons are less tightly held and more readily donated to an electrophile. Sulfur is larger and more polarisable than both oxygen and nitrogen, allowing thiolate ions to donate their electron pair most readily to an electrophile. • increasing basicity: thiolate < alkoxide < azanide Sulfur is a large atom, and the negative charge is dispersed over a larger volume. This stabilises the anion, making the lone pair of electrons less available to accept a proton and therefore least basic. Oxygen is smaller than sulfur, so the negative charge is concentrated in a smaller volume, making alkoxide less stabilise and the lone pair of electrons more available to accept a proton. Nitrogen is less electronegative than oxygen, so the lone pair of electrons are less tightly held and more readily donated and accepts a proton. (ii) rate = k [(CH3)3CO−] [CH3Br] In methyl bromide, the carbon bearing the bromine atom is sterically unhindered. This allows the nucleophile to approach easily from the backside, and reaction takes place via S N2 pathway. (iii) C C CH3 CH3H H C O CH3 CH3 CH3 CH2CH3 C S CH3 H CH3 CH2CH3 C C CH3 HH H N P Q R (iv) ● Elimination (E1) ● C Br CH3 CH3 CH3 + − slow C+ CH3 CH3 CH3 + Br− ● C + CH3 C CH3 H H H CH3CH2S− C C CH3 CH3H H + CH3CH2SH (v) Elimination produce the relatively unstable ethene as it is not substituted. Hence, substitution predominates. (b) (i) In the enolate conjugate base, t
Content continues in the PDF. Download PDF
